Knauf Readygips

Indoor for wallpaper and coatable skimming of wall and ceiling plasters.
(gypsum, lime, lime-cement plasters), of concrete surfaces and aerated concrete.
Joint filling of gypsum boards with SE and TE edges together with joint tape by hand.
As finish on gypsum board joints, already filled with Knauf Uniflott or Knauf Fugenfuller flush with the board surface.
For skimming of the entire gypsum board surface as background for the creating of surface quality level “Q4”.
Knauf Readygips is not appropriate to fill joints of perforated boards.
Filling in the joints of gypsum boards along with a Joint tape up to Q2 surface quality.
Finishing and skim coating entire gypsum board surfaces before applying paint on walls and ceilings up to Q4 surface quality.
Renovation works, as well as general repairing works.

The background has to be dry, even, dust-free, and clean.
Knauf Boards should be applied tightly on a steady sub-construction, clean, and with dust-free joints.
Uneven surfaces should be filled with Knauf Readygips or Knauf Uniflott to create a smooth substrate.
Pre-filled areas must be dry and be well adjusted to the board surface.
Filling and covering of joints should only take place after the boards have been allowed to rest in the given humidity and temperature zones.
longitudinal changes can be expected, i.e. expansion or contraction.
In the case of mastic asphalt screed, fill in joints after the screed has been applied.
Readygips are used as it is in the bucket. In case Readygips hardens, add water and mix with an electric-powered mixer.
For long periods of not being in use, the edges of the bucket should be cleaned, and a safety cap.
After the end of the work, all tools and buckets should be cleaned with water.
Readygips should not be mixed with others materials.
It should not be applied in temperatures under °5+c. Consumption is approximately for jointing 0.25 kg/m2 for finishing 1.5 kg/m2 each 1mm thickness.