Avionics & Electronics Backshells & Strain Relief

202K121-25/225-0 Molded Heat-Shrinkable Straight Boot, 150°C, Fit Size 9 Backshell

MPN
202K121-25/225-0
SKU
53904
Category
Backshells & Strain Relief
Capability
Avionics & Electronics

202K121-25/225-0 Molded Part, Heat-Shrinkable, Straight, 150 °C, Fit Size 9 Backshell — TE Connectivity Raychem heat-shrinkable moulded straight transition boot in semi-rigid elastomer, adhesive lined, rated for 150 degrees C service. Price on request — submit an RFQ for pricing, lead time and documentation requirements.

What to include in your RFQ →

Description

202K121-25/225-0 Molded Part, Heat-Shrinkable, Straight, 150 °C, Fit Size 9 Backshell — BOLTON SKU 53904.

About the 202K121-25/225-0 Backshell

The 202K121 range from TE Connectivity Raychem consists of moulded, heat-shrinkable parts used to seal and strain-relieve the transition between a connector backshell and the cable or harness behind it. This variant has a straight body form and is moulded in a black semi-rigid elastomer with an internal adhesive lining, so that on recovery the boot both grips the substrate and forms a moisture seal. Published data for the part gives an operating temperature range of -70 degrees C to +150 degrees C and a recovery temperature window of +135 degrees C to +200 degrees C, meaning it is installed with a controlled hot-air source rather than an open flame. The part designation identifies it as fitting a size 9 backshell, and the boot is installed after the harness has been terminated and tested.

Key specifications

Manufacturer range TE Connectivity Raychem 202K121 moulded parts
Type Heat-shrinkable moulded transition boot
Body form Straight
Material Semi-rigid elastomer, black
Adhesive Internally adhesive lined
Operating temperature -70 degrees C to +150 degrees C
Recovery temperature +135 degrees C to +200 degrees C
Backshell fit size 9 (per part designation)

Typical applications

Moulded heat-shrink boots are standard consumables in aerospace and defence harness manufacture, used to environmentally seal connector-to-cable transitions on airframe looms, UAV payload harnesses and vehicle wiring. They are equally common in MRO workshops during loom repair and re-termination. Selection is normally driven by backshell size, cable bundle diameter and the temperature class of the installation.

Supplied by BOLTON Technical Equipment Supplies against request for quotation. Add this item to your RFQ basket to request pricing, lead time and documentation requirements (e.g. CoC, datasheets or test reports where applicable).

Browse more in Backshells & Strain Relief.

Reviews

There are no reviews yet.

Be the first to review “202K121-25/225-0 Molded Heat-Shrinkable Straight Boot, 150°C, Fit Size 9 Backshell”

Your email address will not be published. Required fields are marked *

Documentation & RFQ readiness

BOLTON sources and supplies to specification. Documentation availability depends on the product, its manufacturer/supplier source and your stated requirement, and can be confirmed during quotation. To get an accurate quote quickly, include:

  • The exact manufacturer part number (MPN) and quantity required
  • Any drawing, specification or standard that applies, where relevant
  • Required documentation — e.g. certificate of conformity, datasheet, test report, SDS/TDS, calibration certificate or traceability, where applicable
  • Delivery location and required-by date

Explore related categories