Avionics & Electronics · Electronic Components
ELECTRONIC TRANSFORMER FOR HALOGEN LAMPS 12V 60W DIMMABLE
SKU 11710
Brand Osram
Category Electronic Components
Capability Avionics & Electronics
Technical data
Line current 0.25 A
Nominal voltage 220…240 V
Mains frequency 50…60 Hz
Nominal output voltage 11.9 / 12.0 V 1)
Lamp wattage 20…60 W
System wattage 64.00 W
Operating frequency 45 kHz 2)
Power factor λ 0.95 3)
Overload protection Yes
Max. cable length to lamp/LED module 2.0 m
Dimmable Yes
Dimming range 0…100 %
Approval marks – approval: CE
Standards Acc. to IEC 61347-2-2
Type of protection IP20
What to include in your RFQ →
Price on request
Add to RFQ Basket or use the RFQ form→ We source and supply to specification — request a quote with your part number, quantity and required documentation.
Description
This ET-A 60/220-240 built-in electronic transformer is exclusively designed. Direct replacement of built-in magnetic transformers in the simple. Halogen lamp fittings for indoor applications (e.g. halogen lamp kits, hanging lamps, ceiling lamps and etc). A non-reversible fail-safe mode circuit has been specially integrated to ensure safety in case of any operational fault. Important information for the installation As the unit is powered by mains voltage During installation, power to the electronic transformer and the fixture must be disconnected at all times. Connect the lamps to the electronic transformer according to the schematic drawing as shown below. The mains cable and the lamp supply cables must not cross each other The mounting place must be sufficiently ventilated, with the surrounding. the area was maintained clear of any objects (e.g. air conditioning ducts or insulation). If the transformer is used for purposes other than originally intended or connected incorrectly, no liability can be taken over for possible damages The transformers are designed to run one or Three bulbs at a maximum total of 60W The total lamp wattage must be within the values indicated by transformer Fa (20-60W). A minimum lamp load of 35W is required for the smooth effect of leading-edge phase control dimming
Check out our Amazon. ae Store:
Documentation & RFQ readiness BOLTON sources and supplies to specification. Documentation availability depends on the product, its manufacturer/supplier source and your stated requirement, and can be confirmed during quotation. To get an accurate quote quickly, include:
The exact manufacturer part number (MPN) and quantity required Any drawing, specification or standard that applies, where relevant Required documentation — e.g. certificate of conformity, datasheet, test report, SDS/TDS, calibration certificate or traceability, where applicable Delivery location and required-by date
Explore related categories
Reviews
There are no reviews yet.